Generate Detections in Detection Lab
Preview Feature
Cribl is still developing this Preview feature. We don’t recommend using it in a production environment, because the feature might not be fully tested or optimized for performance, and related documentation could be incomplete.
Access requires App Platform, the Cribl Detect feature, and a Role that grants
Apps.Readaccess to the Cribl Detect app.Please continue to submit feedback through normal Cribl support channels, but assistance might be limited while the feature remains in Preview.
Detection Lab uses Cribl AI plus public CVE metadata to create ATT&CK-aligned event-detection drafts and correlation searches. Use it when Templates doesn’t already have the coverage you need.
You don’t create a lab. You enter a CVE identifier, and Cribl AI generates one or more detections from that CVE’s public metadata.
Detection Lab requires AI Investigator. If AI Investigator isn’t available, Generate detections is disabled.
Generate Detections from a CVE
- In Cribl Detect, go to Detections > Detection Lab.
- In the prompt, enter a CVE identifier, such as
CVE-2021-44228. - Select the arrow next to the prompt.
The page heading is What can we get started? The prompt uses Cribl AI plus public CVE metadata to create ATT&CK-aligned detections.
While Cribl AI works, the page shows Generating detections for that CVE. This usually takes two to three minutes, because Cribl AI writes each detection rule in its own pass. You can visit other pages while generation runs. Keep the browser tab open. Closing or reloading it cancels the run.
Progress includes the current step, which detection rule Cribl AI is writing, and elapsed time. For example: Step 8 of 16 / Writing detection rule 5 of 8.
Review Generated Detections
When the run finishes, Detection Lab stays on What can we get started? with the CVE still in the prompt. You can start another identifier without leaving the page. Below the prompt, the generating banner is replaced by the CVE results.
The Overview section shows the CVE Identifier, Severity, CVSS, and Published date. The generated analysis includes additional context and data sources.
Detection Lab organizes the generated results into three steps.
Step 1: Proposed Rules and Coverage
Proposed rules and coverage lists the generated detection drafts in a table. Review each draft’s State once saved, detection point, log source, severity, MITRE coverage, and available actions to confirm that your environment can support the rule. Select Edit to review or change the rule before adding the draft to Inventory.
Generated rules are Enabled on save. When you save a selected rule to Inventory, Cribl Detect enables it on the detection engine for its type.
Step 2: Correlation Searches
Correlation searches lists the additional Cribl Search rules that Cribl AI generated. Each card summarizes a correlation search and the data it requires. Review the search logic before saving the rule.
Step 3: Recommended Next Steps
Recommended next steps describes follow-up work based on the generated rules and their data requirements. Complete the applicable recommendations before relying on the detections in your environment.
Edit a Generated Rule
Select Edit to open a modal titled Edit generated rule, followed by the rule ID. Review or change the rule, then save it to Inventory when it’s ready.
In Inventory, you can disable or edit a saved detection like any other detection.